They will be on the ceiling fan side of the receiver and will have labels showing the motor conductor, the light conductor, and the neutral conductor. Your new remote receiver will have the same black, blue, and white wires as those inside the cover. Next are the black and blue wires.ĭisconnect both by twisting the wires from the black wire of the electrical box. These two white wires will need to be separated. Find the white wires that connect to the electrical box from the ceiling to the fan. Inside, you should see the ceiling fan wiring and the hanging bracket attached to the electrical cabinet. Remove the motor cover from the ceiling fan. Put the screws away in a secure location. Using a ladder, carefully remove the four screws that hold the fan cover in place. Before you begin, remove the remote receiver from all packaging and prepare all tools. The power supply must be switched off at the circuit breaker. When working with electrical installations, it is recommended to test the new conductor with a non-contact voltage tester before handling.īe sure to turn off the fan power before beginning any electrical project. These are the wires that will connect to your new remote-control receiver. And the white wire is the neutral wire for the motor and light. The black wire from the ceiling fan supplies the fan motor. When you open the ceiling fan cover, you will see the three main wires that connect the motor to the light. The energy passes through the condenser of the fan motor and creates torque to rotate the fan blades. The ceiling fan works with an electric motor that contains rotating motor coils. The other receivers have extra steps and are securely fastened to the wall. Inside the fan cover, this receiver is wired. Self-help with a few tools is required to install the Harbor Breeze ceiling fan remote control receiver in the fan shroud. The fanlight and fan speed may both be changed using the remote control. How to Install a Remote Control for a Harbor Breeze Ceiling FanĬonfiguring remote control activation allows you to switch on the Harbor Breeze ceiling fan from the comfort of your couch by pushing a button. Press the “Hi,” “Med,” and “Lo” buttons on the remote control within 20 seconds to switch to the fan.Restore power to the Harbor Breeze fan by turning the appropriate circuit breaker to the “On” position.Replace the remote control battery and battery cover.Remember that the DIP switches on both units must agree to work properly for the fan and remote control. Compare the DIP switches on the fan remote control with the DIP switches on your fan receiver.Remove the battery from the remote control to access the DIP switches at the bottom of the empty battery compartment. Remove the battery cover from the rear of the Harbor Breeze remote control that came with the fan. Turn the switch that controls your fan to the “Off” position to eliminate the risk of electric shock. Open the service panel cover to access the switches. Turn off the power to the Harbor Breeze fan from your home’s electrical service panel before attempting to program.Follow these simple programming instructions to change the direction of the Harbor Breeze ceiling fan remote control in five minutes or less. Many Harbor Breeze ceiling fan models come with a remote control programmed to control the unit. Harbor Breeze is a famous ceiling fan brand.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |